1988 Johnson Evinrude CC 60 thru 75 outboards Service Manual, Page 168Get this manual
Inspection 1Before any inspection process can begin, all internal components must be clean and free of excess oil 2Make visual inspection of all internal componentsCheck for unusual wear patterns, scuffing or deterioration of aluminum parts, heat-related discoloration of bearings or bearing surfaces, and broken componentsr::;;l 3Check for cylinder head warpage using piece of bar stock or machinist's straightedge and feeler gauge set
Cylinder head warpage must not exceed 0.004 in(0,10 mm) end to endResurface or replace head if warpage exceeds this dimension
4Use micrometer to measure the diameter of each and main bearing journalThe lower main bearing journal would only be measured if the bearing was removed for another reasonRefer to Engine Specifications, Section 1, for dimensions
!J crankpin
5Use telescoping gauge or inside-reading micrometer to inspect each cylinder bore for an out-of-round, oversize, or tapered conditionBe sure the gauge or micrometer is perfectly square in the bore when measuring6Measure each cylinder in at least two areas as shownEach area should be measured twiceThe difference between the two measurements in each area is the cylinder out-ofround dimension The cylinder must not be out of round by more than 0.003 in(0,08 mm)