1988 Johnson Evinrude CC 60 thru 75 outboards Service Manual, Page 144Get this manual
CMove the red lead to cavity "C Crank the engine and observe the meter If the meter reads 0.3 volt or higher, go to Step 5Power Pack Cranking Tests Using C.DVoltmeter If the meter reads below 0.3 volt on any test, check condition of the component wiring and connectorsVerify pin location in the connectors If problem with the wiring or connectors is found, correct the problem and retest the sensor coil output If condition of the wiring and connector is acceptable, refer to Sensor Coil Ohmmeter TestSensor Coil Ohmmeter Test
INote All o.hmmeter tests must be performed with engine NOT
runningInsert jumper wires into the "A," "B," "C," and "0" terminals in the timer base end of the connector