1988 Johnson Evinrude CC 60 thru 75 outboards Service Manual, Page 131Get this manual
Ignition Component Replacement Ignition Coil Removal 1Twist and remove the high tension lead and primary leads from the ignition coils2Notice the fastener and washer orientation before removing any screws3Remove the coil mounting screws and remove the coil and washersIgnition Coil Installation 1Assemble the correct sequence of washers and locate the ignition coil on the powerheadInstall and tighten the retaining screws to torque of 48-96 inIbs(5,4-10,8 Nm)2Apply light coating of OMC Triple-Guard grease to the ribbed portion of the spark plug ceramics and to the openings of each of the high tension lead coversInstall the high tension leads3Apply light coating of OMC Triple-Guard grease to the opening of each primary lead cover and install the coversObserve proper wire routing and ignition timing: connect orangeblue lead to top ignition coil, orange lead to center ignition coil and orangegreen lead to bottom ignition coil