1988 Johnson Evinrude CC 60 thru 75 outboards Service Manual, Page 107Get this manual
Assembly Before proceeding, be sure that all parts are perfectly clean Be sure that all replacement parts match original ones in size and shapeReplace all gaskets, O-rings, and sealing washers each time you assemble carburetor Isl
EJ Install with convex side upSecurely flatten each plug with flat
end punch and plastic malletApply Gasoila sealer to the edge of plug2If removed, install new lead shotsFlatten lead shot with flat end punch and plastic malletCheck for leaks
1If removed, install new calibration pocket core plugs
3Install nozzle well gasket 4Install float valve seat and gasket Install inlet needle, clip, float and hinge pin
6Adjust float levelInvert the carburetor bodyWith the float valve closed, the float's top edge should be between, but not touching the notches of OMC Gauge PI 324891as shown