1988 Johnson Evinrude CC 60 thru 75 outboards Service Manual, Page 92Get this manual
Component Servicing Oil Supply Hose and Pickup Assembly
If you suspect that the oil supply to the restricted, check two areas
pump is being
1Remove the pickup assembly and inspect for clogged or contaminated filter Remove the four No25 Torx screws and remove the pickup assembly from the reservoir Carefully remove the pickup filter and flush with mild solvent to remove any contamination Install the filter, being careful not to move the pickup assembly on its support rods
2With the pickup assembly out of the reservoir, vacuum test the system to check for air leaks Carefully remove the oil hose from pickup assembly and from engine oil inlet fitting Use low pressure air to purge hose of oil Use cap holder PI 329661 hose121