1988 Johnson/Evinrude "CC" 40 thru 55 Models Service Manual, Page 232Get this manual
I 12911301 5
Oil, then install new bearings in the bearing housing using OMC Bearing Installer PIN 326562 Press against the lettered side of the bearing to prevent damage to the bearings when installinghousing using OMC Propeller Shaft Bearing Housing Seal Installer, PIN 326551 Apply OMC Gasket Sealing Compound to the metal casing of the seals before installingInstall the inner seal with lip facing toward the bearing housing and install the outer seal with lip facing away from the bearing housingApply OMC Triple-Guard grease to the seal lips after installingLightly apply OMC Triple-Guard grease to new bearing housing O-ringInstall the O-ring in groove of the housingInstall new O-rings on the retaining screwsDriveshaft Bearing Housing Servicing If the needle bearing in the housing is worn, the bearing and housing must be replaced as an assembly
rJ1l13216Install new seals back to back in the rear of the bearing