1988 Johnson/Evinrude "CC" 40 thru 55 Models Service Manual, Page 176Get this manual
51Install the remaining ignition, electrical, and fuel system components ill cal and ignition wiring is routed and clamped in its original
positionInstallation 1Using OMC Lifting Eye PIN 321537, pieces of OMC Universal Puller Set PIN 378103, and suitable hoistlift the powerhead assembly from the workstand2Place new base gasket on the exhaust housing adapterInstall dry, use no sealer
To prevent possible fire or explosion, make sure all electri-
1511 3Apply OMC Moly Lube to the driveshaft splines4Lower the powerhead assembly into place
5Coat the eight powerhead retaining screws with OMC Gasket Sealing Compound and install themTorque screws to 168-192 inIbs(19-22 Nm)6Install one powerhead retaining nut and torque to 216-240 inIbs(25-27 Nm)7Install front and rear exhaust housing covers8Install the four screws that attach the power head to the lower engine cover