1988 Johnson/Evinrude "CC" 40 thru 55 Models Service Manual, Page 139Get this manual
Armature Plate ServicingAll Models Removal
1To avoid accidental starting of engine while servicing, twist and remove all spark plug leads
2If equipped, remove the manual starterSee Section 73Remove the flywheelRefer to Removal of Flywheel4Remove the armature plate leads from the support clamps r:t9l 5Loosen the screws attaching the armature plate to the retainer plate, and lift the armature plate from the powerhead f2nl 6The retainer plate and support plate may be removed (if necessary for servicing) by disconnecting the throttle lever to armature plate link, then removing the screws from the support plateInstallation
on the crankcase Next, position the support plate over the retainer plate and align the holes between the plate and crankcaseApply OMC Nut Lock to threads of screwsInstall the screws and tighten to torque of 48 -60 inIbs(5 -7 Nm)Reconnect the throttle lever to armature plate link201 1If removed for servicing, install the retainer plate