1988 "CC" Colt / Junior thru 8 Models Service Manual, P/N 507659, Page 272Get this manual
Replacement of Starter RopeColt, Junior thru 4BR
19l 1Pull
EJ tension while removing handleUntie knot in end of rope and remove handle and bumper
out starter rope and tie slip knot to relieve spring
Pull starter rope out to limitHold pulley firmly so it will not rewind and release slip knotWhile still holding pulley irmly, remove rope by pulling knotted end of rope from pulleyCarefully allow pulley to slowly rotate until it is fully unwound
3Cut new rope to length of 59 in (151 cm) Fuse both endsKnot one end of rope4Wind spring by turning pulley three and one -half turns counterclockwise and hold in place5While holding pulley from unwinding, insert unknotted rope end into hole in pulley, thread around pulley and out the hole in the starter housing Pull the rope until knot bottoms in pulley6While holding free end of rope outside starter housing, release pulley and allow spring to begin winding rope onto pulley7When there is still approximately 12 in(30 cm) of rope outside the starter housing, tie slip knot in the rope to hold in place