1988 "CC" Colt / Junior thru 8 Models Service Manual, P/N 507659, Page 254Get this manual
139 113Oil new water pump grommet and install it in the pump housing as shown
140 14Apply OMC Needle Bearing Assembly Grease to the
impeller drive pin driveshaft
and place the pin on the flat of the
Slide the water pump housing down over the driveshaft and engage the water pump impeller drive pin and then rotate the housing until the screw holes line upOnly rotate the water pump housing in counterclockwise direction to prevent the impeller blades from being turned backwardsOnce the screw holes line up, seat the water pump in position Coat the three screws with OMC Gasket Sealing Compound, install them and tighten the screws to torque of 25-35 inIbs(2,8-4,0 Nm)
1421143 1164 odelsTo assemble the propeller shaft compo-
nents, place the spring between the gear and the shaftThe tang end of the spring faces the gearAssemble by turning the gear counterclockwise while pushing together