1988 "CC" Colt / Junior thru 8 Models Service Manual, P/N 507659, Page 238Get this manual
Installation 1Insert the stop button wires and the throttle cable through the grommet in the lower engine cover2Apply OMC Triple-Guard grease to the two steering handle bushingsPlace the bushings into the steering bracketAttach the steering handle to the steering bracket3Secure the stop button ground lead to the powerhead4Using OMC Pin Insert Tool PI 322697, insert the stop button pin lead into "E" cavity of the plug CQA1588
1201 5f21l
Thread the throttle cable connector, then the pivot onto the cable
6To adjust the throttle cable: Set the idle adjustment knob to the minimum idle speed Attach the throttle cable pivot pin to the throttle lever Turn the throttle grip to the FAST position as far as grip will turn Have the armature plate in full advance position Turn he cable connector until attachment hole in connector is aligned with mounting location Turn the connector one or two additional turns to preload the cable Secure the cable connectorCheck to see that the twist grip will advance the armature plate to maximum advance stop Check to see that the cam follower is off the cam when the twist grip is set at idle position If full throttle or minimum idle is not attainable, turn the cable connector one turn at time until setting is correct Be sure all fasteners are tight