1988 "CC" Colt / Junior thru 8 Models Service Manual, P/N 507659, Page 210Get this manual
Assembly Proceed slowlyMake no forced assemblies unless pressing operation is called forAll internal components must be perfectly clean and lightly coated with Johnson or Evinrude Outboard Lubricant1Note Use new gaskets, oil retainers, and O-rings during assembly
1If removed, install wrist pin bearing using OMC Bearing Installer and Remover PIN 327645When installing wrist pin bearing the oil hole line up with the hole in rod end
r-:)Jr:;-:;-J 2Using OMC Cone PI 333142 and Driver PI N
333141, install one snap ring in groove of piston When installed, gap of the ring should be positioned opposite groove in the piston
Heat the piston to 200 F- 400 F(93 C- 204 CUsing OMC Piston Cradle PIN 326573 and OMC Pressing Pin PI 333141oil and start the wrist pin into the piston opposite the installed retaining ringDo not allow the wrist pin to enter the piston cavity