1988 "CC" Colt / Junior thru 8 Models Service Manual, P/N 507659, Page 197Get this manual
1321331 BEVELED EDGE lower bearing retaining ringring must 25Install the with OUTThe gap of retaining be centered around the oil hole
in the front of the crankcase
1321133 diameter of new lower crankshaft seal the outside 26Apply GMC Gasket Sealing Compound to Install the
seal with lip facing up towards flywheel, until seal bottoms on the retaining ring27Check for binding between the crankshaft and the bearings or connecting rods by rotating the crankshaft with the flywheel
134 28Apply GMC Gasket Sealing Compound to both sides of
a new cylinder head gasketGasket has boss to match the cylinder headInstall the cylinder head and torque the screws in stages to 60-84 in Ibs(7-9 N'm), following sequence shown29Apply GMC Gasket Sealing Compound to new exhaust cover gasketInstall the exhaust coverTighten the screws to torque of 25-35 inIbs(3-4 N'm), starting with the center screws30Install the intake manifold and leaf plate assembly using new gasketDo not apply sealer to the gasketTighten the screws to torque of 60-84 in Ibs(7 -9 Nm)