1988 "CC" Colt / Junior thru 8 Models Service Manual, P/N 507659, Page 186Get this manual

1988 "CC" Colt / Junior thru 8 Models Service Manual, P/N 507659, Page 186

Installation
1Coat driveshaft splines with OMC Moly LubeDo not coat top surface of shaft as lubricant here may prevent seating of driveshaft in crankshaft2Apply OMC Gasket Sealing Compound to new powerhead to exhaust housing gasketInstall the powerheadStarting with center screws, tighten the six screws to torque of 60-84 in Ibs(7 -9 Nm)
1201 3Position the mounting bracket on the powerheadInstall
4 Install the choke lever and the low speed adjustment knob
the mounting bracket and air silencer with the two front screwsInstall the two rear screws retaining the mounting bracket to the powerhead
120 5Position the fuel tank on the mounting bracket and secure 1221 6Install the starter housing as follows:

Back to 1988 "CC" Colt / Junior thru 8 Models Service Manual, P/N 507659