1988 "CC" Colt / Junior thru 8 Models Service Manual, P/N 507659, Page 145Get this manual
Power Pack Removal 1Separate the power pack connectorTwist and remove the primary lead covers from the ignition coils 2Notice the fastener, washer, wire, and clamp locations before removing any screws
3Remove the power pack mounting screws and remove the power pack and washersPower Pack InstallationDeluxe thru 8
1Clean the power pack mounting bosses to provide clean engine ground2Assemble the correct sequence of washers and locate the power pack on the powerhead or ignition bracket3Carefully install the power pack ground lead where indicated and install the retaining screwsTighten the screws to torque of 60-84 inIbs(7-9 Nm)4 Apply isopropyl alcohol to the Amphenol connectorsAlign flat areas and carefully plug togetherSecure with wire retainer where used 5Lightly coat the openings of the primary lead covers and install them on ignition coil terminals Observe proper wire routing and ignition timingrefer to Ignition Coil In stallationPower Pack Installation.5, UltraExcel 4