1988 "CC" Colt / Junior thru 8 Models Service Manual, P/N 507659, Page 135Get this manual
Installation r=f511Install the flywheel key with outer edge parallel to centerline of the crankshaft and single upset mark facing down I ,
INote Make certain the single mark is facing down[!J 2Install cam
CDSide marked "TOP"
must be up
rGl3 ApplY coating of OMC Mol'tLube to the armature support plate cD and retaining ring Q9Install retaining ring with tapered side down CDThen, install wave -washer and support plateAlign retaining ring with the armature plate Do NOT add oil or grease to the oiler wickPlace the armature plate in position over the crankshaft, avoiding damage to the breaker armsCam follower must NOT be caught under the throttle control camTighten the Phillips screwsAdjust the breaker pointsBreaker Point Adjustment 1For breaker point adjustment, magneto must be assembled to powerhead and flywheel must be removed 2Connect all leads to breaker point assemblies
[!2] Disconnect the ignition coil ground leads118l4Calibrate ohmmeter on high ohms scaleConnect one lead