1988 "CC" Colt / Junior thru 8 Models Service Manual, P/N 507659, Page 133Get this manual
Installation 1If flywheel key has been removed, reassemble to crankshaft with outer edge parallel to crankshaft centerline2If removed, install magneto cam drive pin CD in crankshaftApply OMC Nut Lock to the cam drive pin before installing Install cam ), making certain that side marked "TOP" is up3Apply light coating of OMC Moly Lube to the inside diameter of the armature plate liner Igl
Install washer and liner on crankcaseCurved side of liner tab must face crankcase
5Place the armature plate in position over the liner with the liner tab in slot in armature plate hubMake sure that throttle cam follower is not caught under throttle control camInsert screw and tighten just enough to hold armature plate in selected position yet allow it to be turned without excessive effortConnect ground wire to exhaust coverBreaker Point Adjustment 1For breaker point adjustment, magneto must be assembled to powerhead and flywheel must be removed Move armature plate lever to FAST position (full advance)2Rotate crankshaft clockwise until breaker arm rubbing block is on high point of cam