1988 "CC" Colt / Junior thru 8 Models Service Manual, P/N 507659, Page 132Get this manual
Magneto ServicingColt, Junior Models Removal
1To avoid accidental starting of engine while servicing, twist and remove all spark plug leads
2Remove the manual starterSee Section 73Remove the flywheelSee Removal of FlywheelIf servicing only the breaker points, condenser, and coil; they can be checked and replaced without removing armature plate from motorf314If necessary to service armature plate bushing or high tension lead, remove exhaust cover screw to detach the armature plate ground wire Remove screw below armature plate
INotel Remove screw
plate clamp
before attempting to remove armature
t!J washer High tension lead can be removed by removing
f415Lift armature plate from crankcase Remove liner
on bottom side of armature plate
Disassembly All components may be removed from the armature plate by removing the attaching screwsThe spark plug high tension lead can be pulled from the ignition coilFor cleaning, inspection, testing and repair, refer to Magneto Ignition SystemsGeneral InformationAssembly Assemble components which were removed from the magneto armature plateFollow the reverse order of disassembly and pay particular attention to the following: f511 Correct locating of the ignition coil is governed by machined mounting surfaces on the armature plateCoil lamination heels should be flush with machined surfaces