1988 "CC" Colt / Junior thru 8 Models Service Manual, P/N 507659, Page 104Get this manual
Assembly
Before proceeding, be sure that all parts are perfectly clean Be sure that all replacement parts match original ones in size and shape Replace all gaskets, O-rings, and sealing washers each time you assemble carburetor1Install and tighten the high-speed nozzle Install new float chamber boss gasket 2Replace float valve seat
E.J and floathinge pin CD and spring clip in carburetor body3Check for correct positioning of float levelFloat level controls the height of fuel in the float chamber and is very critical with regard to carburetor calibration and function
and gasketfloat valve
carburetor body upside down and hold so gasket surface is horizontalThe weight of the float will close the float valve needleRest OMC Float Gauge PI 324891 CD on gasket surface, and slide gauge up next to floatTop of float should be between notches on float gauge Be certain gauge is not holding down the float If float level is not between the notches of gauge, lightly bend metal float arm to adjust levelBe careful not to force float needle valve into seat