1987 Johnson/Evinrude CU Outboards 35A thru 55 Service Manual, Page 296Get this manual
Installation of Control Cables into Remote ControlSurface Mount
Cable Installation, Starboard 1Place terminal eye of shift cable over pivot pin on shift cable arm, as shownPlace shift cable trunnion in locating hole in remote control, as shown
INote I'f the terminal cableof remote cable will not seat on pivot eye pin, straighten to eliminate any twisting in cableThis
will allow cable end to lie flat on pivot pin
2Hold shift cable terminal eye in position on pivot pin and install washer and cotter pin Bend cotter pin around pivot pin as shown
of throttle cable over throttle lever pivot pin Place throttle cable trunnion in locating hole in remote control, as shownInstall washer and cotter pin CDBend cotter pin around pivot pin
i lever is positioned as shownPlace terminal eye