1987 Johnson/Evinrude CU Outboards 35A thru 55 Service Manual, Page 287Get this manual
3Lubricate cable ends with OMC Triple-Guard grease4Begin cable installation with housing half of controlMove throttle lever arm from behind plastic plate to expose hole in lever armDo not remove plastic separator plate from housingIf it is missing, cable pins will fall outPlace eyelet of throttle cable between the halves of the throttle lever armin line with holesGrease cable pin CD and drop cable pin through upper lever arm, through eyelet, and into lower lever arm fJ11 '"
Grease cable trunnion pocket and insert cable trunnion 1l into trunnion pocket in housing half
1331613417
The throttle lever arm must be in the idle position before reassemblyMove the throttle lever arm forward toward the front of the housing half until it contacts the stopGrease trunnion pocket in cover halfGrease cable pin and place eyelet of shift cable between the shift lever halves, and press 'table trunnion into trunnion pocket in cover halfInsert cable pin