1987 Johnson/Evinrude CU Outboards 35A thru 55 Service Manual, Page 286Get this manual
1261 1127111128112128113128114128115 i spring into housingTo prevent possible eye injury
10Install detent rollerdetent shoeand detent
from detent spring, wear safety glasses while installing shift and throttle platePlace spring washer onto splined hub of shift and throttle plate
Be sure shift and throttle plate are free of dirt and gritInstall shift and throttle plate bushing into housingRetract detent spring and install shift and throttle plateTeeth of shift and rthrottle plate must engage teeth of shift lever assemblyPlace neutral start switch mounting plate in positionInstall neutral start switch with two screwsTighten screws to torque of 25-35 inIbs(2,8-3,9 Nm)Install fricti?n adjust.ment lever with friction adjustment screw Into hOUSing
Install retainer plate CD to housingTighten screw to torque of 25-35 inIbs(1,8-3,9 Nm)5901
16Check to be sure no wires are being pinchedLubricate shift lever post and three assembly screws with OMC Triple-Guard grease17Reassemble two halves of remote control, taking care to properly pilot the electrical cable grommet into the housingTighten screws to torque of 40-50 inIbs(4,6-5,5 Nm)Pull up on the neutral lock slide and install handle spline into spline of remote control so slide will engage notch of index plateInstall Allen head screwTighten screw to torque of 70-80 inIbs(8-9 Nm)