1987 Johnson/Evinrude CU Outboards 35A thru 55 Service Manual, Page 264Get this manual
Assembly 1Lubricate the armature shaft bearing surface with one drop of SAE No10 oilLubricate pinion helix on armature shaft with General Electric Versilube[]] 2If removed, install retaining ring and washer end of armature shaft on drive
3Assemble drive end cappinionanti-drift springand spacer to drive end of armature shaftInstall new locknutUsing strap wrench to prevent damage to armature, tighten nut to torque of 27-34 Nm (240-300 inIbs 20-25 ftIbs4Assemble armature to frame and magnet assembly, aligning marks on drive cap end and frame 5Install insulated brush and terminal set in commutator end cap with long lead in slotPosition the insulatorsflat washer CD, lockwasher 0, and nut as shown in figure
INote Reversing these brushes will cause motor to run backwards[IQJ 6[TI] 7Install brush holder CD, brush springs, and ground brushesScrews secure ground brush leads and holderInsert insulated brushes in holderAssemble commutator end cap to frame and field aligning notch and rib suitable tool for holding brushes in place can be made from putty knife8Put drop of oil on thru-bolts before assembling starter motorInstall thru-bolts Tighten thru-bolts to torque of 11-12 N'm (95-110 inIbsSeal with OMC Black Neoprene Dip around end caps22160 L!J-_ _-'