1987 Johnson/Evinrude CU Outboards 35A thru 55 Service Manual, Page 188Get this manual
Steering Handle Servicing Removal 1Avoid accidental starting of motorDisconnect the connector between the charge coil and power pack
rv andRemove the from the throttle cablecable bracket2pivot connectorthrottle jam nut
3Remove the stop button ground lead from the powerhead
4Using OMC Pin Removal Tool PIN 322698, remove the stop button lead from cavity "E" of the plug5Shift the motor to FORWARD gear positionRemove the nut and flat washer from the shift rodDisconnect the shift rod from the shift lever6Remove the steering handle screw and nutlift the handle from the steering bracketPull the throttle cable and stop button leads through the grommet in the lower engine coverDisassembly
1Using OMC Twist Grip Remover PIN 390676, depress the grip detentsTighten screw and remove the grip by pulling grip and turning the idle adjustment knob clockwise2Remove the helix halvesrollers and guides 3Pull the throttle pin out of the cable]f51