1987 Johnson/Evinrude CU Outboards 35A thru 55 Service Manual, Page 152Get this manual
Step 1 Charge Coil Running Tests Using .DVoltmeter and Adapter
Charge Coil Output TestSeparate the five-wire connector and plug both ends into the adapterSet the voltmeter switches to "-" and "500 Turn all the adapter switches to ON
all tester leads so they do not interfere with moving eng me parts
black lead in jack "D Start the engine and run at RPM where problem existsObserve the meterStop the engine If the meter indicates continuous reading of 250 volts or higher, the charge coil is OKProceed to Step 2Sensor Coil Running Tests Using C.DVoltmeter and Adapter No or low meter reading, refer to Charge Coil Ground Test
A Place the meter red lead in jack "A" and the meter