1987 Johnson/Evinrude CU Outboards 35A thru 55 Service Manual, Page 91Get this manual
Fuel Pump Replacement 1Remove and discard tie straps from fuel pump hosesModels using hose clamps use OMC Hose Clamp Wrench PIN 325043 to release clampsRemove the hoses from the fuel pump, observing hose locations for reassembly2Remove the fuel pump mounting screwsIf equipped with gasket, discard the gasket3Connect the hoses to the fuel pumpBe sure the hoses are fully engaged on the fuel pump nipplesSecure the fuel hose with new tie straps using OMC Tie Strap Installation Tool PIN 3237164Remove all old adhesive from fuel pump mounting screwsApply OMC Locquic Primer and OMC Nut Lock to the threads of the screwsIf gasket is required between the fuel pump and the crankcase, install the gasketTighten the mounting screws to torque of 24-36 inIbs(2,8-4,4 Nm)5If removed, install the cover with lip of screen facing the fuel pumpTighten the outer screw to torque of 10-15 in Ibs(1,11,7 Nm)Be sure the hose is fully engaged on the fuel cover nipple and secure the hose with new tie strapsqueezing primer bulb until definite pressure is felt in the bulbIt is recommended that new fuel filter element and gasket be installed when servicing the filter and pump assembly ill and