1985 OMC 65, 100 and 155 HP Models Commercial Service Manual, PN 507450-D, Page 376Get this manual
C0 817 CO B5634
7Push core wire (from engine end) through wire clamp Q) until wire protrudes approximately 0,8 mm (132) from end of casing guide Secure core wire in clamp as followsTurn set screw in on large end of wire clamp until it touches core wire, then tighten exactly one more turnThis kinks and locates core wireGrease trunnion pocket of controlLift throttle cable and rotate cable forward until trunnion cap can be inserted into trunnion pocket of controlPosition throttle lever by hand to al ign rear hex screw with access hole in controlI nsert hex wrench through hole and tighten set screw
8The throttle lever arm must be in the idle position before reassemblyMove the throttle lever arm forward toward the front of housing half until it contacts the stop Grease trunnion pocket in cover halfPlace casing guide of shift cable between halves of shift lever and shift cable trunnion cap in pocket of housing Grease outside diameter of wire clamp Insert clamp through shift lever and casing guide