1985 OMC 65, 100 and 155 HP Models Commercial Service Manual, PN 507450-D, Page 359Get this manual
Replacement of RectifierRegulator Assembly100 Power TrimTilt Models and 155 Models 1Disconnect the battery cables at the battery2Remove the rectifierregulator assembly yellow, yellow gray, gray and purple leads from the terminal board3Remove the rectifierregu lator red lead from the starter solenoid4Remove the flywheel and stator from the powerhead as described in Section 35Remove the six screws retaining the rectifierregulator assembly to the powerhead6To install, apply OMC Gasket Sealing Compound to new rectifierregulator assembly gasket7Place the gasket and the rectifierregulator assembly on the powerheadApply OMC Gasket Sealing Compound to threads of the six retaining screwsInstall and tighten the screws to torque of 7-9 Nm (60-84 in Ibs8Install the stator and the flywheel as described in Section 3