1985 OMC 65, 100 and 155 HP Models Commercial Service Manual, PN 507450-D, Page 329Get this manual
8Bend the inside loop of the rewind spring in toward the center of the starter housingEngage the slot of the pulley with the inner loop of the rewind spring and install the pulley in the starter housing 9Place the friction plate spring washer and the friction plate on the pulley hub Secure the friction plate and friction plate spring washer with the pulley lockring 10Be sure the starter pawl bushing is installed in the pulleyApply OMC Triple-Guard Grease or Lubriplate 777 to boss of the starter pawlPlace spring washer on the boss of the starter pawlPlace the starter pawl in the pulley11Position the starter housing spring in the starter housing12Install the starter pawl plate return spring on the starter pawl plate Press the other end of spring on the boss of the pulleyPosition the starter pawl plate on the pulley CD