1985 OMC 65, 100 and 155 HP Models Commercial Service Manual, PN 507450-D, Page 280Get this manual

1985 OMC 65, 100 and 155 HP Models Commercial Service Manual, PN 507450-D, Page 280

5Move shift rod from side to side while pushing on the propeller shaft to ensure proper alignment of the bearing housing locator pin into the locator pin hole in the gearcaseTap the end of the propeller shaft with plastic or rawhide mallet to fully seat the bearing housing6Apply OMC Gasket Sealing Compound to the threads of the sh ift rod cover screwsInstall the screwsTighten the screws to torque of 7-9 Nm (60-84 inIbs7Position the driveshaft thrust bearing washer shim(s) (selected earlier) onto the driveshaft and

INotel Position

exactly

in order shown

Back to 1985 OMC 65, 100 and 155 HP Models Commercial Service Manual, PN 507450-D