1985 OMC 65, 100 and 155 HP Models Commercial Service Manual, PN 507450-D, Page 256Get this manual
6Remove the stop switch assembly from the inner handleRemove the seal from the inner handleCleaning Inspection and Repair 1I nspect the throttle cable for kinks and wearReplace if necessary2I nspect the steering handle components for wear, cracks and other damageReplace damaged parts3Refer to Section 8, Electrical System, to test the stop switch assembly Reassembly of Steering Handle65 Models
1I nstall the stop switch assembly into the inner handleTab on the stop switch goes into recess of the inner handlePlace the seal over the stop switch wires and insert in recess2Install the metal outer handle over the plaxtic inner handle and drive the outer handle into place3I nstall the handle end of the throttle cable through the seal the throttle cable trunnion into recess in handleI nsert the stop switch eye term inal lead through the sleeveLubricate the throttle cable and insert the cable and the other stop switch lead through the sleeve