1985 OMC 65, 100 and 155 HP Models Commercial Service Manual, PN 507450-D, Page 194Get this manual
Removal of Powerhead65 Avoid accidental starting of motorDisconnect the electrical connector between the armature plate and the power packAlso, if the motor is electric start, disconnect the battery cables at the battery2On manual start modelsremove the starter assembly as described in Section Remove the three screws retaining the starter ratchet to the flywheelRemove the screw retaining the starter lockout cab le clamp to the starboard lower engine cover bracketDisconnect the cable from the shift leverOn manual start and tiller electric models: Remove the thrott le cable pivot screws1
the connector
Remove the cotter pin and washer from the shift rod yoke
to the shift leverRemove the shift rod yoke pin and