1985 OMC 65, 100 and 155 HP Models Commercial Service Manual, PN 507450-D, Page 183Get this manual
Ignition Coil Replacement100 Models Removal 1Separate the two -wire connector between the power pack and ignition coils2Twist and pull on the cover to remove the high tension lead from the ignition coil
3Release the ignition coil wires from the support clamps, and remove the coil mounting screws4Remove the ignition coil terminal from the two-wire con nector
Installation 1Insert the ignition coil terminal into the two -wire connector
2Align arrows and reconnect the two-wire connector, and secure with retainer
11001_ _
o provid proper termlna contact
Carefully align the connector halves during assembly to