1985 OMC 65, 100 and 155 HP Models Commercial Service Manual, PN 507450-D, Page 66Get this manual
7Adjust the throttle yoke on throttle lever rod to distance of 12,6 cm mm (4-3132" 132"from aft end of the rod to the aft end of the yoke8Move throttle lever against throttle stop screw valves go full open so throttle
9Turn idle adjustment screw to contact stopAfter screw contacts stop turn screw 1-12 turns to set initial idle speed10Tiller Models: Attach throttle cable to throttle lever using pivot screwTurn idle adjusting knob counterclockwise to end of its travelTurn idle adjusting knob clockwise turns, turn twist grip to slowest position and then adjust throttle cable connector so that the throttle cam is mm mm (116" 132"from roller while taking back-lash out of linkage by pushing top of throttle cam to the rearI nstall throttle cable connector mounting screw&
Tighten mounting and pivot screws securely
11Remote Models: Move throttle lever against idle stop screw Adjust stop screw so that the throttle cam is mm mm (116132") from cam roller while taking back-lash out of linkage by pushing top of throttle cam to the rear