1985 OMC 65, 100 and 155 HP Models Commercial Service Manual, PN 507450-D, Page 36Get this manual
General Specifications Torque Chart
Failure to comply with recommended torque values could result in operator injury or motor damage
Standard Screws and Nuts NmNo.6 No.8 No10 No12 14" 516" 38" 16" 0,8-1,2 6-2,4 2,8-4,0 4,0-4,6 7-9 14-16 24-27 38-40 In-Lbs 7-10 15-22 25-35 35-40 60-80 120-140 220-240 340-360 FtLbs
2-3 3-4 5-7 10-12 18-20 28-30
These torque values apply unless otherwise specified
When tightening two or more screws on the same part, DO NOT tighten screws completely, one at timeTo avoid distortion of the part, first tighten all screws together to one-third of specified torque, then to two-third of specified torque, then torque down completely
Power Trim and Tilt Reservoir
Place motor in full tilt position and engage trail lockRemove filler plug and check fluid levelIf necessary, add OMC Power TrimTilt Fluid to bring fluid level even with bottom of fill holeDisengage trail lock and operate unit through several tilt cyclesRecheck fluid level and add fluid if necessary