1981 Johnson/Evinrude 4HP Outboards Service Manual, Page 77Get this manual
1Inside Loop 2Outside Loop Figure
7-8Starter Spring in Housing
Figure 7-9Lubricating Spring Cavity
CLEANING, INSPECTION, AND REPAIR
aWash metal components in solvent and dry with compressed airbInspect spring for worn or broken end loopscExamine pawl for weardInspect friction spring, spindle, and retaining ring eI nspect rope and discard if frayedBe sure to replace with rope cut to 62-1 inches (158 cm) Fuse ends of rope fExamine pulley and housing for sharp edges and rough surfaces that could fray ropeFile and polish to remove
1Loop in slot
REASSEMBLY OF STARTER
Figure 7-10Positioning Starter Spring