1980 Johnson 4HP Service Manual, Page 79Get this manual
dPosition knotted end of in slot in pulley and coil counterclockwise around pulley flangeSee Figure 7-10If installing new length should measure 64 inches (162 Tie knot in end of Install pulley plate with three screwsload pulley spring 3-12 turns winding pulley counterclockwiseSee Figure 7-11!73008
Figure 7-12Installing Handle
gUncoil just enough to feed through forward hole in starter housing, grommet, and handleTie knot in to retain handlemove rod punch, and install remaining plate screwhInstall starter pawl, friction spring, and taining ringPull handle and observe pawl to see that it extends out when is pulled, and retracts when handle is returned to housing