1980 Johnson 4HP Service Manual, Page 49Get this manual
INSTALLATION Reconnect the three wire connector 181
Care'ully align the connector halves during assembIy to provide terminal contact
Insert the ignition coil terminal into the three wire connectorSecure with retainer
insure ignition timing check the No1 ignition coi! orange !ead to sure it is in the termina! the connector, and that it connects to the orange bIue stripe wire the power packApply Screw Lock (P 384848) to mounting screwsMount the ignition coil to the engine with the lockwasher between the ignition coil and ground wire terminalSee Figure 4-44 Torque screws to 4-5 ft Ib (5.6-8.0 N.m) dSecure the high tension lead to the spark pug 1234Engine Lockwasher Electrical terminal Flat washernot used whenJ" clamp is used