1980 Johnson 4HP Service Manual, Page 46Get this manual
ARMATURE PLATE INSTALLATION If removed for servicing, install the retainer plate the crankcaseNext, position the support plate over the retainer plate and align the holes between the plate and crankcaseInstall the screws and torque to specifications in Section 2Reconnect the throttle lever to ture plate linkSee Figure 4-36Apply Moly Lube Part No173250 to the crankcase boss (pilot for armature plate) See Figure 4-37 Lubricate the armature plate bearing with light coat of 50:1 outboard lubricantdsure the throttle is behind the following to prevent jamming the throttle leverInsert needle nose pliers into the slots vided and hold the armature plate bearing pressed while guiding the armature plate into positionSee Figure 4-37 fPosition the armature plate with the center of the charge coil in line with the stop the tainer plate and tighten the screws to the torque specified in Section 2See Figure 4-35