1980 Johnson 4HP Service Manual, Page 35Get this manual
insure good electrical contact and securityNo soldering is required when using the Crimping Pliers SAFETY WARNING
avoid personal InJury, securely hold insert tool against shoulder of terminal while installing terminals into connector cavityPosition the insert tool against the shoulder of the terminalSee Figure 4-10 dSupport the connector against flat surface, and push the terminal into the connector until the shoulder the insert tool is at the end of the connectorSee Figure 4-11Reinstall wire retainer connector
CONNECTOR TERMINAL INST ALLATION
Connect togetherboth halves of the connector
Ir11lvJi NOTE
00 not use grease
grease in cavitiesoi that oiout present
Apply isopropyl alcohol connector cavity
acetone into the
IGNITION TEST PROCEDURE