1980 Johnson 2HP Service Manual, Page 32Get this manual
Correct locating of the and lamination assemblies is governed machined mounting surfaces the armature platelamination heels should flush with machined surfacesSee Figure 4-16Alignment of the magneto will simplified with the use of locating ring (special tool part number 17001) machined to fit over three machined bosses the armature plateIf removed, connect the ground lead to the bottom of the armature plateSee Figure Apply Neoprene Dip Part Number 909570) to connection
1;;''11;;;j;;1 NOTE
Do not connect breaker point leads untH after breaker point adjustmentMake sure that new oHer wick is installed under See Figure
W ITH COIL LAMINATION HEELSFLUSH AGAINST RI NG, SCREWS
Figure 4-16
Locating Ring
REASSEMBLY OF
FLYWHEEL
If flywheel key has removed, reassemble to crankshaft with outer edge parallel to centerline of crankshaftSee Figure 4-17If removed, install magneto