1978 Johnson 55 HP Outboards Service Manual, Page 41Get this manual
dInsert the removal tool onto the terminal, and push the terminal from the connectorSee Figure 4-10 cSupport the connector against flat surface, and push the terminal into the connector until the shoulder on the insert tool is at the end of the connectorSee Figure 4-12
Figure 4-10Removing Terminal from Connector ePin and socket terminals may be replaced if damagedCrimp new terminals onto the wire using OMC Crimping Pliers (Special Tool No322696)See Figure 4- for crimping locationIf crimping pliers are not available the terminals can be installed onto the wire using needle nose pliers, and then must be soldered to the wire to insure good electrical contact and securityNo soldering is required when using the OMC Crimping Pliers1Shoulder on tool
Figure 4-12Inserting Terminal
IGNITION TEST PROCEDURE
CONNECTOR TERMINAL INSTALLATION