1978 Johnson 175, 200, 235 HP Outboard Service Manual, Page 156Get this manual
eCheck starter motor with no load testWith 12 volts applied to the motor terminals, maximum current draw should be 90 amperes and minimum speed should be 5500 rpmSee Figure 7-5 If visual inspection of the electrical system shows
all components to be in good condition, an electrical inspectionwill be necessary to determine which component of the charging system is the cause of troubleSee Figure 7-35
INSTALLATION OF STARTER
aPlace starter in position against crankcase, and secure with three screwsSee Figure 7-6Attach clamp to upper mounting screw before tightening screwTorque to 14-16 ftlbs(19-22 N.m)Y ELLOW
bReconnect starter motor leadcReinstall port electrical component bracketSecure with two nuts and one boltSee Figure 7-6KE SW ITCH
YELLOW G AY
TERMIN BLOCK
CHARGING SYSTEM
DESC RIPTION