1978 Johnson 175, 200, 235 HP Outboard Service Manual, Page 106Get this manual
SAFETY WARNING To prevent personal injury, mount the universal puller and lifting eye to the flywheel with the hardened steel bolts supplied with pullerDo not use substitute hardwareiAttach body from Universal Puller (OMC Special Tool #378103) to flywheel with screws and washersTighten screwsThread lifting eye (OMC Special Tool #321537) into puller body until point on lifting eye engages taper in end of crankshaftTighten lifting eyeUSing hOist, lift power head straight up to avoid damaging drive shaft splinesSee Figure 6-17While power head is suspended from hoist, thread the four stud nuts onto the studs until flush with ends of studs to protect threadsjRemove gearcaseSee "Removal of Gearcase See page 6-5 AI!
1Rear rubber mount screws
Figure 6-18Lower Motor Cover Frame and Seal Screws (Indicated by Broad Arrows) (175 and 200 HP Shown)