1978 Johnson 175, 200, 235 HP Outboard Service Manual, Page 75Get this manual
kRemove one screw and one nut each (port and starboard) at front of power headSee Figure 5-191Remove long screws (three each, port and starboard)See Figure 5-19 1Lifting eye #321537 2Universal puller #378103 1Stud nut (one each port and starboard 2Short screws (one each port and starboard) 3Long screws (three each port and starboard)
3Puller set screws and washers
Figure 5-20Removing Stripped Down Power Head crankshaftTighten lightlyLift powe head from exhaust housingSee Figure 5-20nThread nuts onto studs until flush with ends to protect threads oPlace power head on bench with crankcaseside facing up See Figure 5-21
Figure 5-19 Power Head to Adapter Screws and Nuts SAFETY WARNING To prevent personal injury, mount the universal puller and lifting eye to the flywheel with the hardened steel bolts supplied with pullerDo not use substitute hardwaremReinstall the flywhe el and tighten but do not torque flywheel nutAttach body from OMC Universal Puller part number 378103 to flywheel with three screws and washersThread OMC Lifting Eye part number 321537 into body until point engages taper in