1978 Johnson 175, 200, 235 HP Outboard Service Manual, Page 9Get this manual
SECTION GENERAL SERVICE INFORMATION
TABLE OF CONTENTS
PAGE SPECIFICATIONS IGNITION COIL TEST SPECIFICATIONS CLEARANCE CHART TORQUE CHART ST ANDARD SCREWS LUBRICATION CHART GEARCASE LUBRICATION POINTS POWER TRIM AND TILT RESERVOIR ENGINE FUEL AND LUBRICANT BREAK-IN ENGINE SET-UP TUNE-UP PROCEDURE TROUBLE CHECK CHART SUBMERGED MOTORS
2-4 2-4 2-5 2-5
2-6 2-7 2-7 2-8 2-8 2-9 2-11
SAFETY WARNINGS To prevent possible eye injury always wear SAFETY GLASSES while servicing motor The motor cover is machinery guardWhen testing or adjusting running motor, do not allow anything to contact the spinning flywheel Do not operate motor out of waterDo not operate motor in test tank without the proper test wheelEither will result in damage to water pump, overheating, too high RPM, and possible explosion of motor parts To avoid possible operator injury be sure SAFETY DEVICES are installed and properly adjusted while servicing motor Refer to solvent manufacturer's caution label regarding proper use and storage of solvent