1978 Evinrude Outboards 9.9/15HP Service Manual, Page 50Get this manual
cLubricate the armature plate bearing with light coat of OMC outboard lubricantdBe sure the throttle cam is behind the cam follower to prevent jamming the throttle levereInsert needle nose pliers into the slots provided and hold the armature plate bearing compressed while guiding the armature plate into positionSee Figure 4-39fPosition the armature plate with the center of the charge coil in line with the stop on the retainer plate and tighten the screws to the torque specified in Section 2See Figure 4-37, view AOn electric starting models, position the cut-outs in the armature plate assembly as shown in Figure 4-37, view B gSecure the armature plate leads in the two support clampsSee Figure 4-36, view AOn electric starting models, connect the three armature plate leads to the terminal boardBe sure to match the wire colors with those from the rectifierSee Figure 4-36, view BhInstall the flywheeltion (Refer to Flywheel Installa-
1Notch in cover
Figure 4-40Bottom of Armature Plate
CHARGE COIL OR SENSOR COIL REPLACEMENT (STATOR ASSEMBLY REPLACEMENT)