1977 Johnson 2HP Outboards Service Manual, Page 33Get this manual
4-7 Correct 10cating of the coil and 1amination assemblies is governed machined mounting surfaces the armature p1ate1amination hee1s should flush with machined surfacesSee Figure 4-16Alignment of the magneto coil will simp1ified with the use of coil 10cating ring (specia1 too1 part number 317001) machined to fit over three machined bosses the armature p1ateIf removed, connect the ground 1ead to the bottom of the armature p1ateSee Figure App1y Liquid Neoprene to connection WITH COIL HEELS FLUSH AGAINST RING, SCREWS
11;;11:11 NOTE
Do not connect breaker point 1eads until after breaker point adjustmentMake sure that new oiler wick is instal1ed under See Figure
Figure 4-16
Locating Ring
PARALLEL
REASSEMBLY OF
FLYWHEEL