1976 Evinrude 40HP outboards Service Manual, Page 70Get this manual
in position on swivel bracketPlace steering bracket in position in swivel bracketSee Figure 6-22If remov ed, einstall throttle control gear bushing, ge ar, shaft, and pinion to steering bracketcIf removed, attach rubber mounts to exhaust tube assembly, and attach upper front mount to steering bracketPlace exhaust tube assembly, with shift rod and water tube installed, in position on steering bracketdAttach upper side mounts to steering bracket with nuts and washersReplace lower side mount housingsReplace nut and washer at upper front mount4404
Figure 6-21Clamp Screw Fixture
REASSEMLY OF EXHAUST HOUSING AND STERN BRACKET
aAttach port and starboard stern bracketsto swivel bracket, with tilting shaft bolt and strapSee Figure 6-7If installing new swivel plates and retainers, use Clamp Screw Fixture (Special Tool #302435)See Figure 6-21
eIf remov ed, install lower motor cover bracketInstall power head plate and lower motor cover, using new gasketsInstall power head as des ribed in Section 5
INSTALLATION OF GEARCASE TO EXHAUST HOUSING