1976 Evinrude 200 HP Outboards Service Manual, PN 5199, Page 188Get this manual
recessReplace three pump screws, and tighten securelySee Torque ChartReplace pump filterFill cavity inside filter and over pump with OMC Sea Lube Power TrimTilt FluidSee Figure 9-25Replace O-ring on trim motorReplace motor and rotate until motor shaft engages pump shaftPosition motor so that cable is on port side of assemblyReplace and tighten three screws on flangeRESERVOIR AND VALVES To replace pilot valve (V -3) and relief valve (V -1), first replace valve seatsSee Figure 9-18Relief valve seat is shorter and goes in forward holeValve ball, core, and spring follow in that orderReplace filter valve ball and insert filter valve seat with 0- ring end upSlide filter into manifold plate and position plate so that filter is on top of filter valve and all three screw holes line upStart screws and tighten in stages to prevent distortion of manifold plateReplace reservoir sleeve and O-ringAttach reservoir with reservoir screws and tighten securely1234"0" ring Drive tang Locating boss Pump cavity recess 63591